With the film trimmed, you'll now evacuate all of the solution remaining under the film.
Squeegee all the way to the edge to seal the film. If the squeegee does not glide easily over the outside of the film, lubricate the film with more installation solution. As before, use pushing strokes from the center of the glass to the edge, moving from top to bottom.
Next, thoroughly re-wet the film and squeegee the entire film again with push movements. Apply enough pressure to ensure you remove any excess water between the film and the glass. Also, be sure to apply enough installation solution so the squeegee glides easily.
The last important step is to dry the edges of the film. Wrap the squeegee in a folded paper towel and starting 5-6” from the edge, squeegee toward the edge. Any remaining water left under the film should be pushed out at the edge and absorbed by the paper towel.
Repeat if necessary to dry the edges. Once dry, installation is complete - congratulations!
Comments
0 comments
Please sign in to leave a comment.