Step #4 - Wetting the Glass

Once your pieces of film are trimmed to size, it's time to wet the glass with the installation solution.

Before you do this, open the window slightly and place a towel underneath the sash, covering the sill. Close the window on the towel, securing it in place. This will protect your window sill, trim and wall beneath the window from any installation solution that drips down as you work. Place another towel on the floor below the window to catch any additional liquid.

Then spray the glass completely with the solution being careful not to leave any dry spots. Center the spray on the window while avoiding spraying near the edges of the window.

PRO TIP: Wet the window thoroughly, but do not spray any water directly on any of the outer edges. You do not want to flush out any dirt or grit which may still be embedded in the edges.

Move on to the Step #5.